£6.99
In stock
1 x Male – Male Phono Adapter.
1x Female – Female Phono Adapter.
Plastic Sun Visor for 7″ Dash Monitors – as seen in photos.
Clips on to 7-Inch Dash Monitors using 2 small side notches.
Not for random Sat Navs or Built-In Monitors.
***IF UNSURE, CHECK BEFORE PURCHASING – USE THE DIMENSIONS BELOW TO HELP***
Measures approx 17.7cm x 8.3 with a 4.4cm visor top.
*Dash Monitor NOT INCLUDED – visor only.
The Dolphin Automotive Commercial Parking Sensor kit is designed to help with installation on oversized vehicles (compared to your average car) where you may have a longer wheelbase or wide vehicle where a traditional parking sensor kit isn’t going to meet your needs. This Comes with a longer power lead and standard sensors but with extension leads so you can use the extra cabling if needed. The display also has an extension to give you a total length of 10m to get in the cabin. Along with a 4m power lead this should be enough for most vehicles to go from the reversing light (as your power source to activate the sensors) to the front of the vehicle.
This buzzer is the same as those supplied with our most popular award winning reverse parking sensor kits. You can fit it within the lining of the vehicle or under the parcel shelf, it is quite loud so you should be able to hear it from the location that best suits your needs.
The buzzer can be attached using an adhesive strip or for a more permanent / secure fitting 2 screws can be used to screw in the lining of the car
The Dolphin Van Parking Sensors Display kit comes with 4 sensor heads to be mounted into the bumper of the vehicle. It is equipped with extended 6m Parking Sensor Leads and an extended 10m Power Lead. This enables you to route the sensor leads around the width of the bumper and bring the interface box further into the vehicle, should you need to.
The audio buzzer, inside the Visual Display starts to beep at 1.5m and gets progressively faster, the closer you get to the obstacle behind. This becomes a solid, unbroken tone, at 30cm enabling you to get into the tightest of spaces with confidence. The audio buzzer, inside the Visual Display is set at a comfortable pitch, because it is fitted on the dash.
These brackets can be used to easily mount the sensors to vehicles where recessing them into a bumper is neither practical or suitable for the sensor location, such as on vehicles with solid metal bumpers or even no bumpers at all.
12v DC power cable for most reversing cameras.
2.1mm Male Jack Plug
1m Cable Length
Reviews
There are no reviews yet.